View SY10H350JCTR_714598.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

Micrel, Inc.
PECL-to-TTL TRANSLATOR
SY10H350
SY10H350
FEATURES
s s s s Single 5V power supply Propagation delay, 3.5ns typical Fully compatible with MC10H350 Available in 20-pin PLCC package
DESCRIPTION
The SY10H350 consists of 4 translators with differential inputs and TTL outputs. The 3-state outputs can be disabled by applying a HIGH TTL logic level on the common OE input. The SY10H350 is designed to be used primarily in systems incorporating both ECL and TTL logic operating off a common power supply. The separate VCC power pins are not connected internally and thus isolate the noisy TTL VCC runs from the relatively quiet ECL VCC runs on the printed circuit board. The differential inputs allow the H350 to be used as an inverting or noninverting translator, or a differential line receiver. The H350 can also drive CMOS with the addition of a pullup resistor.
BLOCK DIAGRAM
12
PIN NAMES
Pin D0 - D3 Function True PECL Inputs Inverted PECL Inputs TTL Outputs PECL VCC (5.0V) TTL VCC (5.0V) Ground Output Enable
4 3 5 7 8 14 15 17 18 19
/D0 - /D3 Q0 - Q 3 VCCE
9
VCCT GND /OE
13
VCC (+5 VDC) = Pins 2 and 20; GND = Pin 10
M9999-032906 hbwhelp@micrel.com or (408) 955-1690
Rev.: B
Amendment: /0
1
Issue Date: March 2006
Micrel, Inc.
SY10H350
PACKAGE/ORDERING INFORMATION
/D2 /D3 NC D2 D3
Ordering Information(1)
Part Number Package Type J20-1 J20-1 J20-1 J20-1 Operating Range Commercial Commercial Commercial Commercial Package Marking SY10H350JC SY10H350JC SY10H350JZ with Pb-Free bar-line indicator SY10H350JZ with Pb-Free bar-line indicator Lead Finish Sn-Pb Sn-Pb Matte-Sn Matte-Sn
18
17 16 15 14
Q2 19 VCCT 20 NC 1 VCCE Q0 2 3 Top View PLCC J20-1
13 Q3 12 /OE 11 NC 10 GND 9 Q1
SY10H350JC SY10H350JCTR(2) SY10H350JZ(3) SY10H350JZTR(2, 3)
Notes:
4
5
6
7
8
20-Pin PLCC (J20-1)
M9999-032906 hbwhelp@micrel.com or (408) 955-1690
D0
/D0
NC
/D1
D1
1. Contact factory for die availability. Dice are guaranteed at TA = 25C, DC Electricals only. 2. Tape and Reel. 3. Pb-Free package is recommended for new designs.
2
Micrel, Inc.
SY10H350
ABSOLUTE MAXIMUM RATINGS(1)
Symbol VCC VI VO IO TLEAD Tstore TA Parameter Power Supply Voltage PECL Input Voltage Voltage Applied to Output at HIGH State Current Applied to Output at LOW State Lead Temperature (soldering, 20sec.) Storage Temperature Operating Temperature Value -0.5 to +7.0 0V to VCC+0.5 -0.5 to +5.5 Twice the Rated IOL +260 -65 to +150 0 to +85 Unit V V V mA C C C
TRUTH TABLE
/EN L L L H Open D L H Open X X /D H L Open X X Q L H L Z Z
NOTE: 1. Permanent device damage may occur if absolute maximum ratings are exceeded. This is a stress rating only and functional operation is not implied at conditions other than those detailed in the operational sections of this data sheet. Exposure to absolute maximum ratlng conditions for extended periods may affect device reliability.
DC ELECTRICAL CHARACTERISTICS
VCC = 4.75V to 5.25V
TA = 0C Symbol ICC VOH VOL IIH IINH IIL IINL IOS IOZH IOZL VCMR VPP VIH VIL Parameter Power Supply Current Output HIGH Voltage Output LOW Voltage Input HIGH Current (Pin 12) Reverse Current Others Input LOW Current (Pin 12) Forward Current Others Output Short Circuit Current Output Disable Current HIGH Output Disable Current LOW Common Mode Range Minimum Peak-to-Peak Input(1) Input HIGH Voltage (Pin 12) Input LOW Voltage (Pin 12) TTL ECL Min. -- -- 2.7 -- -- -- -- -- -60 -- -50 2.8 200 2.0 -- Max. 20 12 -- 0.5 20 50 -0.6 50 -150 50 +50 VCC -- -- 0.8 Min. -- -- 2.7 -- -- -- -- -- -60 -- -50 2.8 200 2.0 -- TA = +25C Typ. 12 12 -- -- -- -- -- -- -- -- -- -- -- -- -- Max. 20 -- -- 0.5 20 50 -0.6 50 -150 50 +50 VCC -- -- 0.8 TA = +85C Min. -- -- 2.7 -- -- -- -- -- -60 -- -50 2.8 200 2.0 -- Max. 20 12 -- 0.5 20 50 -0.6 50 -150 50 +50 VCC -- -- 0.8 Unit mA V V A A mA A mA A A V mV V V VOUT = 0V VOUT = 2.7V VOUT = 0.5 Condition No output loads IOH = -3.0mA IOL = 20mA
Notes: 1. 200mV input guarantees full logic at output. 2. These values are for VCC = 5.0V. Level Specifications will vary 1:1 VCC.
M9999-032906 hbwhelp@micrel.com or (408) 955-1690
3
Micrel, Inc.
SY10H350
AC ELECTRICAL CHARACTERISTICS
VCC = 4.75V to 5.25V
TA = 0C Symbol tPLH tPHL tpdLZ tpdHZ tpdZL tpdZH tr tf Parameter Propagation Delay D to Output Q Output Disable Time(1) Output Enable Time(1) Output Rise/Fall Time (1.0V to 2.0V) Min. 1.5 2.0 2.0 0.3 Max. 5.0 8.0 8.0 1.6 Min. 1.5 2.0 2.0 0.3 TA = +25C Typ. 3.5 -- -- 0.8 Max. 5.0 8.0 8.0 1.6 TA = +85C Min. 1.5 2.0 2.0 0.3 Max. 5.0 8.0 8.0 1.6 Unit ns ns ns ns Condition CL = 50pF CL = 50pF CL = 50pF CL = 50pF
Notes: 1. Guaranteed, but not tested.
SWITCHING WAVEFORMS
/OE
/OE
1.5V 1.5V
1.5V
TPZL VOUT 1.5V VOL 0.3V TPLZ
1.5V
TPZH
TPHZ VOH
VOUT
1.5V 0.3V
Figure 1. 3-State Output Low Enable and Disable Times
Figure 2. 3-State Output High Enable and Disable Times
+7.0V
Open
1ns/V (typical) 1ns/V (typical) +3.0V 90% INPUT +1.5V 10% 0V tPLH tPHL 80% tPHL tPLH
TPZL, TPLZ D.U.T 50
All Other
50pF
50
COMPLEMENT TRUE
50% 20% tTHL
Includes jig and probe capacitance
tTLH
Figure 3. Test Load *Application Note: Pin 12 is an /OE and the 10H350 is disabled when /OE is at VIH or higher.
Figure 4. Propagation Delay and Transition Times
M9999-032906 hbwhelp@micrel.com or (408) 955-1690
4
Micrel, Inc.
SY10H350
20-PIN PLASTIC LEADED CHIP CARRIER (J20-1)
Rev. 00
MICREL, INC. 2180 FORTUNE DRIVE SAN JOSE, CA 95131
TEL
USA
+ 1 (408) 944-0800
FAX
+ 1 (408) 474-1000
WEB
http://www.micrel.com
The information furnished by Micrel in this data sheet is believed to be accurate and reliable. However, no responsibility is assumed by Micrel for its use. Micrel reserves the right to change circuitry and specifications at any time without notification to the customer. Micrel Products are not designed or authorized for use as components in life support appliances, devices or systems where malfunction of a product can reasonably be expected to result in personal injury. Life support devices or systems are devices or systems that (a) are intended for surgical implant into the body or (b) support or sustain life, and whose failure to perform can be reasonably expected to result in a significant injury to the user. A Purchaser's use or sale of Micrel Products for use in life support appliances, devices or systems is at Purchaser's own risk and Purchaser agrees to fully indemnify Micrel for any damages resulting from such use or sale. (c) 2006 Micrel, Incorporated. M9999-032906 hbwhelp@micrel.com or (408) 955-1690
5

▲Up To Search▲

Price & Availability of SY10H350JCTR

	To Download SY10H350JCTR Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .